Flat roofs

Stripes from oxidized asphalt represent basic group of hydro-isolation stripes - asphalt-protecting material in this case consist from asphalt and mineral filling mass.
Oxidized asphalt is of plastic characteristic - it does not have reversible reaction.
Oxidized stripes have characteristic temperature range 0°C (plasticity at low temperature) up to +70°C (resistant to sagging). At temperature of 0°C on this type of material might appear some splits on protecting substance while at temperature higher than 70°C the asphalt protecting substance begins sagging from the support inlay.
Today stripes from oxidized asphalt are used in roof coating usually as vapour barrier or as lower layer of a multi-layer water resistant insulation.

Maintenance of asphalt-oxidized stripes - classics hydro-isolation stripes from oxidized asphalt is important to protective from UV radiation by reflective coating, which needs to be periodically renovated.

A 330 H PARAFIB - waterproof sheet from absorptive impregnated machine fabrics board without asphalt covering.
It is used as inlay for tough roofing. Roof sheet is for provisory buildings with short time - temporary waterproof function and undemanding vapour proof inhibition. It is not recommended to use it as levelling fabric under asphalt shingle.

R 330 H PARARUBIT - waterproof sheet with carrying absorptive ply from impregnated machine fabrics board with double asphalt covering up to 1mm.
It is used for undemanding temporary roofing, isolation of foundation and against ground moisture, further as safety and levelling ply of roof structure and base sheet for shingle and as separating ply.

PARABIT V 60 S 35 - waterproof sheet with covering ply from oxidized asphalt of more than 1mm and with inlay from glass mat (min. 60 g/m²). It's thickness is of 3.5 mm with fine-grained spreading.
It is used as universal apt for welding waterproof sheet for applications that are not demanding on strength and endurance. Mainly as inner ply of waterproof roof covering and against ground moisture where the power water does not impact.

PARABITGLAS G 200 S 40 - waterproof sheet with covering ply from oxidized asphalt of more than 1mm and with inlay from glass mat (min. 160-230 g/m²). It's thickness is of 3.5 mm with fine-grained spreading. It is used as universal apt for welding waterproof sheet for applications with higher demand on mechanical strength.

PARAALBIT AL S 40 - waterproof sheet with covering ply from oxidized asphalt of more than 1mm and with aluminium foil of 0.06mm thickness, or combined inlays from glass mat and aluminium foil. It is used as vapour proof and radiological protection of buildings.